Print Page - Getting the beast on the center stand...!!!

Title: Getting the beast on the center stand...!!!
Post by: Pawk on October 21, 2003, 10:21:44 PM

What a PITA!!!! :twisted:

I am hoping there is some secret I am not aware of that makes getting this thing on the center stand a little easier.

Basically, I grab the front brake and get a rocking motion going, stand on the foot mount thats on the stand, let go of the brake and pull back. It usually takes a few cycles before I get it. ](*,)

I am 6'2" 200lbs... this seems like it should be easier.

Maybe I'm just a wimp.... :oops:

Title:
Post by: BigDave on October 21, 2003, 10:26:22 PM

This took a few trial & error for me too.

Left hand on left grip. Right hand on passenger peg bracket. Right foot on centerstand foot peg (or whatever it is. The metal part that sticks out a few inches above the actual foot that makes contact with the ground). Just lift a little with your right arm as you motion the bike back a little & bingo. Shes up.

Title:
Post by: RobZ on October 22, 2003, 01:17:48 AM

Quote from: "BigDave"This took a few trial & error for me too.

Left hand on left grip. Right hand on passenger peg bracket. Right foot on centerstand foot peg (or whatever it is. The metal part that sticks out a few inches above the actual foot that makes contact with the ground). Just lift a little with your right arm as you motion the bike back a little & bingo. Shes up.

If done corretly there is almost no effort involved. Be sure and put you weight on the center stand foot peg, a slight rock backwards and a gental lift with the right hand. Presto :D

Title:
Post by: Pawk on October 22, 2003, 03:53:23 AM

I am soooo glad I asked the question.

It is so easy. :D/ :D/ :D/

I used to loathe chain maintenence.

Thanks for the replies

Title:
Post by: nomad on October 25, 2003, 06:49:33 AM

My problem is getting it off the centerstand. Any suggestions?

Title: centre stand
Post by: Peter Melnyk on October 25, 2003, 07:17:37 PM

[I have droped my new tiger twice .once trying to get it on the stand and again taking it off the stand. the bike fell away to the offside and both times I had the panniers on .My last bike was a BMW 1100 gs , boy! putting that heavier bike on the stand was a breeze compared to this baby. must have something to do with good basic engineering instead of oh! we forgot to stick on a stand put it there that will do.

Title:
Post by: blacktiger on October 30, 2003, 08:35:30 PM

I tried the "BigDave Method" this weekend and can not believe how easy it is!.

I used to hate trying to get the damn thing up on the stand. I even managed to chip my garage floor!

Now it comes up even easier than my old Nighthawk.

Thanks!

:D

BMSBIKE

Title:
Post by: raych on November 11, 2003, 07:57:29 PM

Agreed, it comes up easy-peasy when done as Big Dave describes. I find the only awkward bit is getting my foot on to the centre stand lever - it seems to be right behind the pillion footrest bars. I have to push it down with my foot on the stand's side-bar, then wiggle my foot on to the lever while the springs are trying to lift the stand up again.

TigerTriple.com

Talk => Speaking Of Bikes... => Topic started by: Pawk on October 21, 2003, 10:21:44 PM