The Tiger/Trident hybrid build has begun. The first step is getting the Tiger rear shock on the Trident. I was hoping the Tiger shock would fit on the Trident with no changes. No such luck. The swing arm, shock, shock linkage and motor mounts are different. So, I pulled the rear suspension and motor mounts off the Trident. I now have the Tiger motor mounts and swing arm in place on the Trident. The Tiger shock is in place with only the upper bolt.
Now my question: How do these two pieces fit on the linkage? The shop manual does not show them and being an idiot I did not document their exact placement.
The pieces:
(http://i592.photobucket.com/albums/tt4/97tiger885/Trident%20900/Trident%20Head%20Removal/IMG_20140423_191307.jpg)
The location where I believe they go:
(http://i592.photobucket.com/albums/tt4/97tiger885/Trident%20900/Trident%20Head%20Removal/IMG_20140423_191358.jpg)
And the way I think they mount:
(http://i592.photobucket.com/albums/tt4/97tiger885/Trident%20900/Trident%20Head%20Removal/IMG_20140423_191533.jpg)
Yes, no??
Turns out I do have a photo, from the centerstand bracket thread:
(http://i592.photobucket.com/albums/tt4/97tiger885/Tiger/IMG_20140411_165241.jpg)
See schematic on the first post of this: http://www.tigertriple.com/forum/index.php/topic,13380.0.html
That's one of the two brackets that came with the centre stand kit.
I suspect these two pieces are spacers that came with the centerstand kit.
You beat me by just under a minute. Thanks for the info. I DLed the jpeg with the diagram. I probably have the instructions around somewhere, but you saved me the time of searching.