A Few Screws loose

[Gravity Tester]

Well not rely lose more Like I am an Idiot and I can not find where these two 10mm hex head screws go.

Yesterday I changed  Antifreeze on Big Blue (06 Girly) This meant taking the Tank off. When all was said and done I have these two screws left over.They are the same as the two that are under the wind screen holding the cowling to the instrument cluster. I took every thing back off but could not find a home for them. I know this is one of those stupid moves a newbie does but so be it. Any help would be Great.

On a side note I want to say Thank to Stretch for the great instructions for pulling the tank!!! Very Helpful and informative.  Removed a lot of my fears.

My next lesson for this site will be how to add Pictures.

[JTT]

My guess is they are used for the indicator (blinker) panels (the black plastic  panels the indicator stocks are attached to).  These have 3 bolts each holding them on, one at side rear, one on the inside next to the forks, and one at the front, on the underside of the panel/fairing.

[Gravity Tester]

Thanks JTT
As near as I can tell the blinker panel screws all tool to be 5mm head screws. But will look again.

[JTT]

Sorry, reading comprehension is not a strong suit for me obviously    Did you have the fairing off?  There are actually 4 of those cap screws holding the fairing on.

http://www.bikebandit.com/2003-triumph-tiger-955i/o/m121594#sch565862 (http://www.bikebandit.com/2003-triumph-tiger-955i/o/m121594#sch565862)

[Gravity Tester]

JTT
Thank You I never Even saw those holes!!! All Set!!