News:

Welcome to the TigerTriple forum! Over the years we have gathered lots of great information on all things Triumph Tiger. Besides that, this is a great community that is willing to help you keep your Tiger moving. So, feel welcome! Also, try the search button for answers to your questions. If you have any questions, PM me on ghulst.

Main Menu

HEAD BEARING REPLACEMENT ON 885!

Started by 1999_Black_885i, June 04, 2006, 04:27:15 PM

Previous topic - Next topic

1999_Black_885i

Anyone offer advice on replacing head bearings on my bike pleae ?



I.E whats involved..infact what to do period lol.





cheers

tiger feet

I assume that you mean steering head bearings?

Are they really knackered, or do they just need adjusting up a bit?

Without refering to a manual, so put simply, I guess it's as follows:-

Support the bike so the front wheel is off the ground and secure.

Remove front wheel.

Support brake calipers and speedo drive.

Remove front mudguard.

Loosen fork leg clamps.

Undo handle bar clamps protect fairing and bodywork and secure handle bars.

Remove fork legs.

Undo top stem nut.

Separate top and bottom fork yokes.

Remove and replace bearings.

Reverse the above proceedure.

Whilst its apart it would be a good time to change the fork oil?

I did mine by hanging the legs from the garage roof truss until all the old oil had drained out.

Personally, I would want a workshop manual to refer to, just to be safe etc?

I hope this helps a bit?



Best regards,



Tiger Feet.
Four wheels good, two wheels better, three wheels accident!

1999_Black_885i

Dave thanks for the reply.

yes im pretty sure they are knackered as the steering is so bad. Its not just a very slight tight spot -  its so bad you have to exert force to get it past the "flat spot". Very Very alarming !!



As im a "big lad" the front end is softer on my bike than my neighbours 955 i .Would using heavier oil make much difference to this softness?



Cheers for the help !



:-)

tiger feet

Hi again,



I would certainly think it would be worth trying a grade heavier than standard oil, if you are going to change it.

A heavier oil increases the damping effect and slows the 'bobing' that long travel suspension can suffer from.

I would think that it may well also be worth you changing the springs too?

Progressive rate springs are my choice every time.

Spings do age, how old is the bike?

Is it an 885i or original 'steamer'?



Best regards,



Tiger Feet.
Four wheels good, two wheels better, three wheels accident!

1999_Black_885i

yeh its an 885i the clue is in the name lol.



Im def going to go go for heavier oil and chance that it will  make things a bit firmer. Its not that its a problem but just a little firmer might suit. Im not bothered enough to go for diff springs. Thanks again !