96 mikuni stock carb setup.

[dieselr3]

Hello folks hope you all had a good easter.
Was hoping I could get info on how the mikunis are set up stock.Have found a source that stocks fuel cutoff valves so Iam going to be getting into the carbs soon to replace them.
main jet?
pilot jet?
needle jet? and what clip position? mine has 4 grooves,curantly on 3rd groove from top
mixture screw? curantly mine are 2 turns out

Any and all help appreciated thanks

[rf9rider]

Just going through this myself.
On my 94 Steamer, main jets are 105, air mixture screw 2 turns out, but my clip position is in the middle, mine has 5 grooves.
Sure you`ll get more help.  :)

[Mustang]

Search can be your friend .......................just saying :D

http://tigertriple.com/forum/index.php/topic,7543 (http://tigertriple.com/forum/index.php/topic,7543)

and now there is a sticky in the steamer forum for carb info ...............

[dieselr3]

Awesome cheers mustang, just one question,my needles which Im sure are stock as Ive looked up the numbers on other threads have 4 notches and so Im not sure quite where to set them.Ive currantly got them set on the third notch from the top.

[Mustang]

leave it in the third groove  from the top it will make for a fatter midrange