How to install baffles on a Blue Flame can?

[munsonbw]

I just got my Girly a couple weeks back and find the blue flame can with all baffles removed a little annoying cruising at highway speeds.  It seems to drone to me.  I would like to try the baffles, which I have, but want to be sure of the installation method and configuration before I screw something up with the bike or the pipe.  I have what looks like a baffle, a tube about 6" long with a flange, and one that is just a cap.  I ASSUME the baffle goes in the top and the cap in the bottom and are held in with cir-clips?  What configurations are possible/recommended?  Baffle with no cap, cap with no baffle, etc.

I checked the blue flame website and here with no luck so far.

Thanks,
Ben

[Bixxer Bob]

Baffle (long tube)  in the top plug in the bottom and circlips to secure both. Job done, ride and enjoy. This config is uk legal still sounds good and doesn't affect power much.

[munsonbw]

If I understand correctly the configurations to use are:
 - all open
 - plug in bottom, no baffle
 - baffle and plug in

[Bixxer Bob]

Correct. You could add baffle in plug out but that's just daft. In the end it comes down to personal taste and what you local law enforcement will let you get away with  :D