ignition coil plug

[akendall1966]

Forgive me not strictly a Girly question, but....

Would anyone know the make / source of the ignition coil plug i.e mating part for the denso MB029700-8150 ign coil?

Got the T595 tore down for a thorough service and found I got a broken clip on the plastic housing, so would like to replace it before I reassemble.

I am assuming a 855i probably shares the same coil part (pls don't flame me if I am wrong :oops: )

AK

[KuzzinKenny]

Hey akendall1966 !! have a looky here........

http://www.worldoftriumph.com/section.p ... ts_locator

you should be able to cross ref part no.s

or email this lot.............

http://www.triumph-ant.co.uk/

they do know there Triumphs  

KK

[akendall1966]

Nice one KK, just one problem......

22   PFKL1212431   SUB-HARNESS.ENGINE   £197.41   (€232.05)
 :shock:  :shock:

Now I am back up off the floor! I Have been looking at EBAY, Girlies, sprint RS, Daytona 955i all seem to share the same coil plug on the loom so might have to stump up £20-30 for a 2nd hand loom to scavenge parts from.

Have sent a pleading email to Denso UK for a data sheet or info on the connector, will try the same from triumphant / sprint etc.

AK

[John Stenhouse]

If you get a reply with info, please post it up.

[KuzzinKenny]

Nice one KK, just one problem......

22   PFKL1212431   SUB-HARNESS.ENGINE   £197.41   (€232.05)
 :shock:  :shock:

AK

 :shock:  Yikes !!

No idea what the plug looks like, so have a looky here.....

http://www.vehicle-wiring-products.eu/V ... mepage.php  

might be somethin like it  :?

KK

[akendall1966]

Looks like this:



Unfortunately I had check VWP already no joy, I'll take it to work today and see if any of the electronics boys have an idea.

Adrian

[Timbox2]

You could have a look at these, they look similar maybe??


http://www.thetoolboxshop.com/econoseal ... -689-c.asp

[akendall1966]

Sadly again no, the coil connector has round pins approx 4mm dia. And Denso UK have come back and said they cannot help either.

Thanks for the link though.

So I have bitten the bullet and bought a loom of ebay, the up side is I offered 50% of the asking price and they took it so while still an expensive way to get a 2p bit of plastic  I have got a bunch of other stuff, well ... err to sneak past the wife and fill up the garage a bit more.

Cheers to the help - AK

[iansoady]

You could have a look at these, they look similar maybe??


http://www.thetoolboxshop.com/econoseal ... -689-c.asp

Useful link, bookmarked. It's quite hard to find these connectors, especially with a reasonable shipping cost.