Stick coils vs PVL's

[dave NL]

Looks good! Also the connectors look the par! Where did you get the connectors if I may ask?

[GavD]

I've used male spade connectors into the existing wiring loom and tiny female ones onto the sticks so that I can disconnect them from either end. All cables are tiewrapped to the frame spine to keep them away from hot things. Seems to be working fine at the moment.

[NeilD]

yes the more I think about it, the more I'm favoring individual connectors at the loom end..

dave - the connectors came from here...

http://www.kojaycat.com/Motorcycle%20co ... %20way.htm (http://www.kojaycat.com/Motorcycle%20connector%202%20way.htm)

part number SNDC2W  - expensive but they fit..  I was going to go with individual crimp on terminals but wasnt sure about how to seal up the ends etc..

[GavD]

Looks very professional Neil, mines a bit more Heath Robinson!

[NeilD]

, mines a bit more Heath Robinson!

..mine might end up that way   :D

..just hope it sorts out the missfire problem..

[dave NL]

yes the more I think about it, the more I'm favoring individual connectors at the loom end..

dave - the connectors came from here...

http://www.kojaycat.com/Motorcycle%20co ... %20way.htm (http://www.kojaycat.com/Motorcycle%20connector%202%20way.htm)

part number SNDC2W  - expensive but they fit..  I was going to go with individual crimp on terminals but wasnt sure about how to seal up the ends etc..

Great site! Usually its a pain to get connectors other than salvage!