Does anyone know if this stator comes ready to fit with the grommet fitted and the connector attached so that it is just plug and play.
Electrex world seem unable to tell me?????????
Quote from: "HockleyBoy"Does anyone know if this stator comes ready to fit with the grommet fitted and the connector attached so that it is just plug and play.
Electrex world seem unable to tell me?????????
Looks from this that it comes supplied with the grommet 'pre-installed', but the connectors would need to be fitted by you :? :?:
http://www.electrexworld.co.uk/acatalog/G75.html (http://www.electrexworld.co.uk/acatalog/G75.html)
Quote from: "HockleyBoy"Does anyone know if this stator comes ready to fit with the grommet fitted and the connector attached so that it is just plug and play.
Electrex world seem unable to tell me?????????
It didn't when when I put one in my 955 Tiger earlier this year. The grommet does come off the old one, without much agro. Cut the wires close to the grommet and pull them out one at a time. Heat it up a bit (hot water) and use a bit of lube (ooo err) (I used silicone dielectric grease) to slip the new wires through the holes. Trim leads to length, put spades on ends, insert into connector shell.
Thanks, thats what I thought from looking at the picture but wasnt sure.