Print Page - Forks

Title: Forks
Post by: kennyjd on March 23, 2016, 09:28:04 PM

Hello, can anyone tell me how far the forks are pulled through the top yoke from the Factory setting?. regards Kenny.

Title: Re: Forks
Post by: Timbox2 on March 23, 2016, 09:39:52 PM

Factory setting is top of tube inline with top of yoke (Fork top cap just above)

Sorry, might have made that up for the Steamer as I was thinking Girly, also as below, not sure if you mean factory setting or not.

Title: Re: Forks
Post by: JayDub on March 23, 2016, 10:43:47 PM

Quotefrom the Factory setting

Or did you mean you want to lower the front after lowering the rear? mine are good at 15mm.

Title: Re: Forks
Post by: kennyjd on March 24, 2016, 06:14:51 AM

Factory Setting please??

Title: Re: Forks
Post by: Nick Calne on March 24, 2016, 08:20:52 AM

Factory setting = flush with just the cap above
General accepted better way preferred by most here = 10mm or so through.

Title: Re: Forks
Post by: kennyjd on March 24, 2016, 10:13:54 AM

Thanks to everyone who replied, regards Kenny.

Title: Re: Forks
Post by: Sin_Tiger on March 24, 2016, 02:45:32 PM

Stock arrangement.

Title: Re: Forks
Post by: kennyjd on March 24, 2016, 09:22:14 PM

Thanks for that,

TigerTriple.com

Tiger Time => Steamers (1993-1998 Tigers) => Topic started by: kennyjd on March 23, 2016, 09:28:04 PM