Ok guys, I might be at the point where I realize I can't really do much better than the steamer for the budget. So, I might spend a bit more time on him to get him (I couldn't see this big adventurous bike as a girl for some reason... I mean, it isn't a girly ;) ) ready for the new riding season. (Not that the previous season ever ended.)
So, oil, oil filter, brake and clutch fluids are on the list. I did the airfilter and box a mere 400km's ago, it's got reasonably new tires, I revised the fork with new springs last spring and had the rear shock/spring looked at at the same time. Carbs are clean, but might need some syncing.
Other suggestions?
Change the fork oil, it doesn't last as long as you might think.
Grease the suspension linkage (assuming you know that all the bearings are good) or take it apart and have a look.
Give the multiplug connectors a going over if it hasn't been done since you got it.
Check the exhaust joints for leaks.
Don't forget your clutch fluid.
Lube the throttle cable.
Check the wear on the chain rub strip and block, if it's still there.
Check the gas pressure in your shock reservoir.
Drain the fuel tank, buy a little endoscope for your phone (about €20) and examine the inside for crap, guaranteed you will find some treasures
Oh and if you haven't read my :pimp Steamer thread, I'd check inside the alternator end cover, it's only 3 nuts :augie
Bet you didn't think I could come up with a list like that :mut
Agree on electricAl connection blocks,especially the one from ignition switch!
May want to check the front chain sprocket is tight on the shaft. Lot of vibration can come from a loose one.
Quote from: Sin_Tiger on February 17, 2017, 11:10:13 PM
Bet you didn't think I could come up with a list like that :mut
Hahahaha, I'm afraid I was in your case. ;)
I think the fork oil is still good. The bike hasn't done the mileage I had hoped for last year. Exhaust joints are good, the throttle cable is new and I looked through the tank earlier last year when I had to drain it anyway because it was not a fitting size anymore.
Electrical connections are a great idea, as are the rear suspension grease. Really need to get around to that. :)
Spark plugs, brake pads/pins/sliders and piston condition, tank and airbox drain tubes. I often check all the bolts I can such as the brake pedal pivot (mine loosens after a few thousand mls for some reason).
How 'deep' do you want to go??
Strip the bottom shock link,andcheck the bearings etc! Just because it has grease points,doesn't mean .....
Mine was 'f#$%^d'
when I checked!