Hello there guys!
So I have done some work on the ol' steamer. I have replaced the camchain and tensioner and i had to replace the crankshaft due to it getting mashed up :(
so anyway its all back together and its up and running, however there's a horrid vibration as the engine runs. I suspect there's something not right about the new crankshaft.
Am I missing a trick somewhere? I have checked the balancer and the dots are aligned when on the T1 position.
Could it be a main bearing?
:icon_confused:
Please help, I'm stumped, any advice would be great
Brian
It's not going to be a main bearing as that would give you a continous noise. Are you sure you have good coils and they are correctly connected?
Hey Thanks for the reply.
Yeah I thought it was maybe the wrong firing sequence, so have checked that the coils are properly wired up, Red and Green wires to cylinder 1 . Red and Yellow/Blue for 2 . Red and Yellow/Brown for 3.
So, wired up fine, I will now check that both sides of the coils themselves are not shagged.
I do suspect that they are fine though. Will report back.
Thank you
Yep, all coils are fine.
I suspect the replacement crankshaft... is there any way it could be unbalanced or something? It is from a Trophy which should be the exact same.
hmmmmm :icon_scratch: