Currently reassembling the Tiger but when it came to the panels I was left dumbfounded. I can't remember where these panels go...
Any suggestions?
Above the head, bolted to the frame, so they are under the fuel tank near the headstock.
The tank rubber mounts have to be removed, so they slip over the short tube sticking out each side, I think...
Aha, that might be possible...any idea what their use is? Protect the spark plug connectors from something?
Heat deflectors?
There should also be a foam pad/separator that clips in under those piece's that the HT leads pass through.
There is a piece of foam that looks like a toe separator (you know, for polishing toe nails..). Will check either tonight or tomorrow if the caps fit. Not sure if they will deflect much heat though, being just a bit of plastic.
They sit under the fuel tank and protect the coils from all sorts of water, petrol etc, and the foam bits keep the ht leads separate.