Hi All,
New to the forum and got a question about the carb needles:
Anyone know how to identify the standard needles in the Mikuni carbs? The ones in mine have 6 position grooves for the circlip and no identifying marks.
I bought the bike a couple months ago, it's a 1996. A previous owner apparently rejetted it for some track only 'Viper' slip ons. I didn't like the noise or how the bike ran (rough under 3000rpm and fairly thirsty), so I've fitted a set of the stock exhausts, fitted a 40 pilot jet and 105 main and set the idle screw as per one of Mustang's old posts. It runs much better but I think there's room for more improvement, hence questioning if the needles have been changed too.
Thanks in advance!
Off the top of my head, stock Mikuni needles only have 5 grooves (clipped in the middle one), so perhaps "Power Commander" or "Factory" needles have been fitted.
If you are on facebook the T300, tiger 885 steamer. Girly and steamer page, may have some info. Usually, depending on stage the needle won't change just the clip position
Hi Both,
Thanks for the replies.
I worked out that it looks like a dynojet kit had been fitted, as their needles have 6 slots and the idle screw had been set as per the dynojet instructions.
I've put the standard needles in, which has made improvement over 3000rpm and it's using less fuel too.
Still rough under 3k so next job is to check the slide vent holes as the dynojet instructions specified they should be drilled out, so I'll fill them and redrill to standard, then balance the carbs.
I don't suppose anyone knows what size/how many holes the slide vent holes are to save me buying a new one to compare?
Thanks
Sorry, mine are Keihin
There should be two holes in the slide, can't remember the size off the top of my head, use the unblocked one as a guide.
Thanks for the photo SinTiger.
I ended up buying one on the basis I can return it if I don't fit it.
The slide holes are almost exactly 4mm in the new one. The ones in my bike had had inserts fitted to reduce the size, so I've drilled them back out to 4mm. Not sure if it's solved anything as I'm going to change the airbox too as that's been broken/repaired by a previous owner, and I can't be bothered to put it all back together until I have the airbox.
I'll report back once it's all back in one piece.
While you've got it all apart, it's worth giving the carb to head rubbers a really good bending, they can look OK but actually be quite perished. Check they are fitted the right way around with the correct orientation, I've seen them mixed up by "mechanics" who should know better.
When I used to do my Steamer carb's the thing that made fitting and removal far easier was buying a new set of rubber mounts, so much more flexible than an old perished set, and not too expensive. For the saving in time and scraped knuckles well worth the money.
Wow, wish I'd seen this exploded view of the inlet rubbers before refitting the carbies :icon_eek:
I hope I've fitted them the right way around :icon_confused:
Hopefully they are, as the carbies didn't stay inplace the first couple of times we fitted them.
They've held inplace so fingers crossed :icon_scratch: