Whilst giving my 2006 Tiger a full service and cleaning out the throttle bodies plus a new throttle position sensor in an attempt to cure a slow running surging issue below 3k revs.....upon putting it all back together I found a 2 pin connector with yellow/red and brown wires attached.
Not being able to find any other lonely connector I checked a wiring diagram for a Tiger in Haynes manual and it could possibly be for an EVAP valve (California only).
This is a UK bike so I am hoping this is the case as I cannot find anything to connect it to.
Can anybody in UK verify that there is a redundant connector below the air box?
Thanks in advance.
619873EE-165D-4210-9CE5-386A44F944C6.heic
Can't quite make out where it is. If it's towards the front of the bike, it looks like the connector to the front right of the airbox.
Other than that, my Daytona has a similar connector that goes to the coolant temperature sensor, but I can't say for sure if there's one on my 06 Tiger.
I had a quick look at some photos I have when I've had the tank off & the one below appears to show the same connector close to the frame on the right (you may have to zoom in). From memory, that one is to the front side of the airbox.