What is the procedure for replacing the fork oil on a 2001 955? What additional steps are neccessary if I want to change my fork springs and/ or "revalve" the forks. Thanks for the help! :)
Quote from: "stopwatch"What is the procedure for replacing the fork oil on a 2001 955? What additional steps are neccessary if I want to change my fork springs and/ or "revalve" the forks. Thanks for the help! :)
I did this when I installed the RaceTech Gold Valve Cartrige Emulators. It takes about 3 hours (maybe 2 hours just for replacing the oil)
To change the oil or replace the springs:
Take off the wheel
Take off the brake calipers
Take off the front fender
Open the tripple clamps.
Remove both fork legs
Open the fork caps
Pour out the oil
Remove the fork springs
Compress the forks and fill up with new oil as instructed in the manual
Extend the forks
Insert the springs
Close the fork caps
Insert the fork legs back into the tripple clams
Tighten the Tripple clamps
Put the fender, wheel, and brake calipers back in.
To revalve (if you are using cartrige emulators), you will also have to take out the damping rod:
After removing the fork legs from the motorcycle:
Loosen the screw at the bottom of the fork leg. If it does not open, put a helen rench in it and give it a swift wack with a hammer. That should jar it loos a bit. The use the helen rench to open it up until the rod is unattached.
After modifying the damping rod:
Insert the rod back into place
Insert the springs
Close the fork cap
Bolt the rod back into place by closing the bult at the bottom of the fork
Open the fork caps
Remove the springs
Compress the forks and Fill up oil
Insert the cartrige emulators
Insert springs
Close fork caps
Put everything back together as described in the Oil and Spring replacement above
Be careful when closing the fork caps. Make sure you don't force it and distroy the thred. It can be a little tricky if you add the cartrige emulators because there will be more spring preasure due to the added hight of the spring. It's not a big deal, just be carefull.
don't forget to jack up the front wheel before you take off the forks! :lol:
ned
Break the fork caps loose before unclamping the tripple tree, they are tough to keep from turning otherwise.
Quote from: "stopwatch"What additional steps are neccessary if I want to change my fork springs and/ or "revalve" the forks. Thanks for the help! :)
I would'nt go to the expense of a "revalve". Just try some thicker oil in them first. And, maybe, increase the amount of oil in them by 10~20ml. This has the effect of stiffening everything up somewhat.
What I found to be a good way to go was :-
mix 66% 15W with 33% 10W (13.66W??) i.e. 1litre of 15W with 1/2 litre of 10W and reduce the oil level from 119mm (book setting) to 110mm.
Still supple enough for comfort but improved feel & reduces fork dive.