hello everyone,
so i took my 06 to the dealer yesterday(still under warranty) because the engine light came on and was stalling and runnig rough.
today i picked it up and was told the code read tps high voltage input. they cleared the code and is now running normal. i rode about an hour after picking it up and all seems good.
so my question is what could have caused the tps to to send that information. i would not like to be a 3 day ride from home if it happens again.
thanks for any advice, doc
Sometimes I get a code after pulling the tank/disconnecting the battery. A low/old battery will alse get you fault codes. Usually it defaults to limp mode and doesn't run terrible. There may be more to your problem or it might be a random act of electrons.