Does anyone here have 'em and could I cadge a couple of measurements of you? I need the distance from the top engine mounting plate to the outside of the vertical bars and also the distance from the bottom of the vertical bars to the lower mounting point -
Ta muchly in advance if anyone is feelin' generous
hi,
I have a pair of bars overall length is 490mm, 100 out from the tank and 370 mm plate to plate.
I have had them for over 2 years and they are great recently with the handbrake on the back we pulled up on the gravel to adjust the head sets and over balance and the bike went down not a mark on the tank etc. very good. :lol:
thanks - a friend of mine runs a machine shop - says he'll fabricate a set for me if i get some approximate measurements for him - I want 'em in stainless - much appreciated!
Just get your fat ass out of the kitchen and print off a few pics from the web. We can figure it out instead of swilling lake piss while watching MI5
:friday
Quote from: "kelpie_67"Does anyone here have 'em and could I cadge a couple of measurements of you? I need the distance from the top engine mounting plate to the outside of the vertical bars and also the distance from the bottom of the vertical bars to the lower mounting point -
Ta muchly in advance if anyone is feelin' generous
so hurtful- you're just jealous 'cos you don't have proper wheels with spokes!
Sniff. That is just too low.
Quote from: "kelpie_67"so hurtful- you're just jealous 'cos you don't have proper wheels with spokes!