I need to replace my Girly's ignition lock. During a very recent trip to the Cevennes region in the south of France, my bike ended up on a recovery truck when the ignition lock decided to pack up. Lights/indicators/horn - yes; ignition/start - no. Pressing the switch or pushing the key down hard would make a circuit, but we couldn't bodge anything to keep it running. It was eventually bodged by the local town's moto shop man. Despite negative initial impressions, he knew his stuff, and spliced in a handlar-mounted on/off switch to bypass the dodgy circuit.
Now home, I need to replace the switch. What type are the bolts holding the switch assembly to the yoke? To my aging eyes, in a mirror, with a poor light, they look as though they have tiny hex heads. Are they or are they some other devious 'security' bolt? If straight hex, what's the across-flats size? It's certainly small than 5mm - the smallest socket I have. :?:
They should be shear bolts. they break off when they are tight enough. If you can see a hex they may have been replaced
Quote from: "John Stenhouse"They should be shear bolts. they break off when they are tight enough. If you can see a hex they may have been replaced
Ah, I'd read of them being shear bolts, which suggested, er, shearing... :oops:
So, if you need to replace the item secured with shear bolts, how do you do it, without resorting to the very big hammer?
No, they had been sheared off. One was loose and came out with pliers, the other needed drilling out.
Grind or file the head flat first, then centre pop it, then drill it carefully. With a nice sharp drill, some lubricant (3 in 1 will do) and keeping the revs down so as not to burn the drill, it will be easy enough. Once through the heads the lock will come off then you can remove the remains.