I mounted the brackets to my Happy Trails bags today and can't decide on the placement of the boxes on the racks. I thought about leveling them with the rear rack but any top box would probably be in the way. Have you guys drilled and bolted yours on and later wished you had placed them differently ? How high, how far back ?Suggestions and pics would be appreciated ! I'm going to try to get them on in the morning sometime.
You guys seem to be the most knowledgeable group regarding my bike, but I'm posting this on a couple of other forums, so sorry if you end up reading it twice. Thanks again for all of your help
When I mounted a set of Happy Trails to my '06 I used painters tape on the 'wheel side' of the boxes. Make life easy: Use a box or stool to rest the HT boxes on at the height you need. You should place 'stuff' under
to get them as near perfect as you can. ( If you had 3 arms.... life would be good!)
On the backside of the boxes:
1. I placed tape to indicate how high I wanted them: About 1" lower
than seat.
2. I then placed tape to set them back far enough so a passenger
had room for leg/foot... without being cramped.
3. When I decided their angle.... I simply followed the lines of the bike.
Just mark your holes on the tape. The boxes will look fine.
4. With a box in it's 'final position' . . . look it over; Make adjustments;
make certain itis steady and will not move.
5. Mark each mounting hole with a perm marker from the backside, thru
the mounting frame.
6. Drill your holes. That's tough material so drill a pilot hole then a correct
diameter hole.
7. When you mount yor bolts be certain to silicone around them to seal
from moisture. It does not take much.
There's a "what not to do" thread here: http://tigertriple.com/forum/index.php/topic,5793 (http://tigertriple.com/forum/index.php/topic,5793)
Where you can add guidance for others :lol: