Forgive me not strictly a Girly question, but....
Would anyone know the make / source of the ignition coil plug i.e mating part for the denso MB029700-8150 ign coil?
Got the T595 tore down for a thorough service and found I got a broken clip on the plastic housing, so would like to replace it before I reassemble.
I am assuming a 855i probably shares the same coil part (pls don't flame me if I am wrong :oops: )
AK
Hey akendall1966 !! have a looky here........
http://www.worldoftriumph.com/section.p ... ts_locator (http://www.worldoftriumph.com/section.php/4276/1/parts_locator)
you should be able to cross ref part no.s
or email this lot.............
http://www.triumph-ant.co.uk/ (http://www.triumph-ant.co.uk/)
they do know there Triumphs :thumbsup
KK
Nice one KK, just one problem......
22 PFKL1212431 SUB-HARNESS.ENGINE £197.41 (€232.05)
:shock: :shock:
Now I am back up off the floor! I Have been looking at EBAY, Girlies, sprint RS, Daytona 955i all seem to share the same coil plug on the loom so might have to stump up £20-30 for a 2nd hand loom to scavenge parts from.
Have sent a pleading email to Denso UK for a data sheet or info on the connector, will try the same from triumphant / sprint etc.
AK
If you get a reply with info, please post it up.
Quote from: "akendall1966"Nice one KK, just one problem......
22 PFKL1212431 SUB-HARNESS.ENGINE £197.41 (€232.05)
:shock: :shock:
AK
:shock: Yikes !!
No idea what the plug looks like, so have a looky here.....
http://www.vehicle-wiring-products.eu/V ... mepage.php (http://www.vehicle-wiring-products.eu/VWP-onlinestore/home/homepage.php)
might be somethin like it :?
KK
Looks like this:
(http://www.kendalla.f2s.com/PICT0095.JPG)
Unfortunately I had check VWP already no joy, I'll take it to work today and see if any of the electronics boys have an idea.
Adrian
You could have a look at these, they look similar maybe??
http://www.thetoolboxshop.com/econoseal ... -689-c.asp (http://www.thetoolboxshop.com/econoseal-and-junior-timer-connectors-689-c.asp)
Sadly again no, the coil connector has round pins approx 4mm dia. And Denso UK have come back and said they cannot help either. :cry:
Thanks for the link though.
So I have bitten the bullet and bought a loom of ebay, the up side is I offered 50% of the asking price and they took it so while still an expensive way to get a 2p bit of plastic I have got a bunch of other stuff, well ... err to sneak past the wife and fill up the garage a bit more.
Cheers to the help - AK
Quote from: "Timbox2"You could have a look at these, they look similar maybe??
http://www.thetoolboxshop.com/econoseal ... -689-c.asp (http://www.thetoolboxshop.com/econoseal-and-junior-timer-connectors-689-c.asp)
Useful link, bookmarked. It's quite hard to find these connectors, especially with a reasonable shipping cost.