tank from 955i on a 885i?

[cavi]

I know alot of the bodywork works from the 955i to the 885i.  does the gas tank also work?

[Timbox2]

Yes, only caveat is the fuel pump plate. If the tank is off a later 955 and comes with the fuel plate/pump assy, you would have to swap over as the later 955's had a single fuel feed rail.

[cavi]

now you confused me, can I run my older 885i fuel pump and plate on the newer tank or will I also have to swap over to the newer fuel plate and pump assembly?

[JoeDirt]

Yes, only caveat is the fuel pump plate. If the tank is off a later 955 and comes with the fuel plate/pump assy, you would have to swap over as the later 955's had a single fuel feed rail.

Sorry Timbox2, they didn't go to a single line feed until 2006. The '01-'05 955i tigers have a dual feed.

Below is a picture of my '01:

[Chris Canning]

Sorry Timbox2, they didn't go to a single line feed until 2006. The '01-'05 955i tigers have a dual feed.

Below is a picture of my '01:

That's what Tims post says!!

All tanks are the same fuel pump only differs on the later version.

All tanks and plastics in those days where made by Acerbis but as the lead time was 6 months or more Triumph went off and did their own thing.

[Bixxer Bob]

Mine's a 2005 and has a single feed 

[JoeDirt]

Mine's a 2005 and has a single feed 

That's cause you are special. You must of got an early one.

[Timbox2]

Sorry Timbox2, they didn't go to a single line feed until 2006. The '01-'05 955i tigers have a dual feed.

Below is a picture of my '01:

Sorry Joe but my old 05 Tiger had the single feed and it was an 05 Model with the earlier engine cases

[Dev_1]

I just picked up a cheap '06 955i air box for my 2k 885i. I had do install a pcv style fitting for my crankcase hose, cut a second snorkle inlet, and make a size-up fitting for the drain hose on the right-hand-side. All said and done, it seems to be working well....and no blanking plate!