Throttle bodies vacuum tubes DIY

[tigergotcha]

A good replacement for the OEM tubes(with rubber boots always cracking) are silicon tubes 6mm ID, 3mm wall thickness. If you want to keep the corrugated ones you can use pieces of the same silicone tube to just replace boots (it's a tight fit, perfectly working).You cannot see attachments on this board.You cannot see attachments on this board.You cannot see attachments on this board.   

[Lee337]

I've replaced the ones on my Daytona with similar silicone hoses, just not red ones 

[HockleyBoy]

 

[wyaTT37]

A good replacement for the OEM tubes(with rubber boots always cracking) are silicon tubes 6mm ID, 3mm wall thickness. If you want to keep the corrugated ones you can use pieces of the same silicone tube to just replace boots (it's a tight fit, perfectly working).You cannot see attachments on this board.You cannot see attachments on this board.You cannot see attachments on this board.   

[Flyingwombat]

Just done this myself after seeing a vacuum leak