Tiger Parts Cross-Reference Guide

[Bixxer Bob]

mikuni in the UK:

http://www.tigertriple.com/forum/index.php/topic,12241.0.html

[wardy]

do you know which clutch levers they were off as i am trying to find a adjustable clutch lever for my 1999 885i

[Bixxer Bob]

Wardy, wot you on about mate?

[Sin_Tiger]

do you know which clutch levers they were off as i am trying to find a adjustable clutch lever for my 1999 885i

Think they are the same for most Triumphs since 2000

[PeteH]

Assorted spares to be found on Sprint manufacturing inc this caliper boot http://www.triumphparts.gbr.cc/product.php/5733850/
I picked this up today from my local dealer......
Found this too....http://www.squaredeals-ltd.co.uk/brake---caliper-mcyl-piston--seal-kits-468-c.asp

[HockleyBoy]

http://www.squaredeals-ltd.co.uk/triumph-brake-caliper-shaft-bolt-rubber-boot-5747-p.asp (http://www.squaredeals-ltd.co.uk/triumph-brake-caliper-shaft-bolt-rubber-boot-5747-p.asp)

Or Honda part No 45132166016 if you need one in a hurry (as I did on Saturday!) and there is a Honda dealer nearby.

[rex007can]

Is there an equivalent for a clutch cable on a 2001 tiger with bar risers?  Can't seem to find it here... 

[John Stenhouse]

Not sure that's been asked before, but it can't be too difficult the ends aren't anything special.

[rex007can]

Yeah,  didn't seem that specific to me either.  Anyone know the length I need maybe?

[John Stenhouse]

Measured my spare cable a standard one is 47inches or 120cms long, add a bit for the risers.......

[rex007can]

Is that the cable itself or the sleeve?

[John Stenhouse]

All of it, cable end to end including the sleeve which is obviously shorter.

[bemusedinsojo]

Master Cylinder Rebuild Kit Kawasaki KZ1000 ZL1000 ZR1000 ZX1000 Ninja ZR1100 worked like a charm.

[Madruss]

Square shaped mirrors from an early 80's Kawasaki four-cylinder 750, look very similar by comparison to the units on my '96 Steamer, if anyone is chasing "look a-like" replacements

[Sin_Tiger]

A very close replacement for the originals, a fraction longer arm also used by Honda, is available from Busch & Muller as attached.

Another close one is a "folding stalk" from somewhere just west of Guangzhou, they don't look terribly robust, the stalk is slightly on the short side, the view can get slightly fuzzy at motorway speed but so far have stood up and the view is wide, undistorted and clear. (I'll add a photo later)